Introduction

Use this guide if you are having troubles getting your speakers to work at optimal performance or if there is no sound coming out of your speakers at all.

Pièces

Aucune pièce nécessaire.

  1. Using a plastic opening tool, remove the two rubber tabs circled in red.
    • Using a plastic opening tool, remove the two rubber tabs circled in red.

  2. Remove both of the 8mm Phillips #2 screws from these slots where the rubber caps were removed.
    • Remove both of the 8mm Phillips #2 screws from these slots where the rubber caps were removed.

    • Slide the tab to pop the battery out of its holder.

    • Pull the battery out of its slot.

    • Remove the three 4mm Phillips #2 screws from the open battery slot as shown.

    • Remove the two 5mm Phillips #2 screws.

    • Begin prying up on the plate as shown in the pictures.

    • Detach the single connector using your plastic opening tool.

    • Remove the speaker bar.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tanner

Membre depuis le 21/09/2018

761 Réputation

5 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 31

Total : 39