Réparez vos affaires Communauté Boutique

BLU Dash JR D140 Digitizer Replacement

Introduction

Screens on these phones can crack easily, using this guide you can have a clean brand new slick look again! It is also a nice way to get under the screen and remove dust particles.

Ce dont vous avez besoin

  1. BLU Dash JR D140 Digitizer Replacement, Battery: étape 1, image 1 de 1

    • Turn off the phone first. Press the power button continuously for 2-3 seconds to shut down the phone.

    • Using a plastic opening tool, pry open the back cover from the slit on the bottom right corner of the phone.

    Traduire

  2. BLU Dash JR D140 Digitizer Replacement: étape 2, image 1 de 1

    • Using a plastic opening tool or finger, pull out the battery.

    Traduire

  3. BLU Dash JR D140 Digitizer Replacement, Digitizer: étape 3, image 1 de 1

    • Remove the four 4.0mm Phillips #1 screws.

    Traduire

  4. BLU Dash JR D140 Digitizer Replacement: étape 4, image 1 de 1

    • Starting from a corner, separate the panel from the frame using the plastic opening tool.

    • The volume button will pop out.

    Traduire

  6. BLU Dash JR D140 Digitizer Replacement: étape 5, image 1 de 1

    • Unscrew the 3.6mm Phillips #0 screw from the motherboard.

    Traduire

  7. BLU Dash JR D140 Digitizer Replacement: étape 6, image 1 de 1

    • Using a spudger, lift the black ZIF connector at the top left corner of the phone.

    Traduire

  8. BLU Dash JR D140 Digitizer Replacement: étape 7, image 1 de 1

    • Pull the ribbon cable out of the ZIF connector.

    Traduire

  9. BLU Dash JR D140 Digitizer Replacement: étape 8, image 1 de 1

    • When the ribbon cable is removed from the ZIF connector, peel off the power, sticky button using a plastic opening tool.

    Traduire

  10. BLU Dash JR D140 Digitizer Replacement: étape 9, image 1 de 1

    • Peel off the volume sticky button.

    Traduire

  11. BLU Dash JR D140 Digitizer Replacement: étape 10, image 1 de 2 BLU Dash JR D140 Digitizer Replacement: étape 10, image 2 de 2

    • Separate the screen cover from the motherboard using the plastic opening tool. And don't forget that your phone can mess up if u separate the motherboard from the screen cover

    • Make sure that the LCD screen stays attached to the motherboard while doing this.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autres ont terminé cette réparation.

Auteur

avec 6 autres contributeurs

Nathanael

Membre depuis le 07/23/15

233 Réputation

1 tutoriel rédigé

Badges: 9

+ 6 badges supplémentaires

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 5

30 derniers jours : 10

Total : 1,205