Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

The back camera may become damaged or scratched over time, causing poor quality pictures. This guide will explain how to access, remove, and replace your BLU Life X8 back camera.

  1. Flip the phone over so that the screen is facing down. Slide the opening tool between the micro-USB port and the back cover.
    • Flip the phone over so that the screen is facing down.

    • Slide the opening tool between the micro-USB port and the back cover.

    • Use the opening tool to create a gap.

  2. Use your thumb to pry off the back panel once the gap is large enough.
    • Use your thumb to pry off the back panel once the gap is large enough.

  3. Once the back panel is off, locate the indent at the bottom of the battery.
    • Once the back panel is off, locate the indent at the bottom of the battery.

    • Use your thumb to slip the battery out of the case.

  4. Le kit d'outils Essentiel

    Les outils les plus utiles dans notre kit le plus compact.

    J'achète

    Le kit d'outils Essentiel

    Les outils les plus utiles dans notre kit le plus compact.

    J'achète
  5. Use the Phillips #00 (1.5mm) bit to undo the (9) screws from the back of the device. Use the Phillips #00 (1.5mm) bit to undo the (9) screws from the back of the device.
    • Use the Phillips #00 (1.5mm) bit to undo the (9) screws from the back of the device.

  6. Wedge the opening tool into the seam of between the screen and the gray frame.
    • Wedge the opening tool into the seam of between the screen and the gray frame.

    • Run the opening tool along the seam to release the clips that hold the two pieces together.

    • You may need to use the opening picks to prevent the clips from reengaging.

  7. Once all the clips have been released, pull back the frame and set it aside.
    • Once all the clips have been released, pull back the frame and set it aside.

  8. Use the tweezers to unlock the ribbon cable from the motherboard
    • Use the tweezers to unlock the ribbon cable from the motherboard

    • The ribbon cable should be free. Pull back on the ribbons to release it from the connector

  9. Lift the back camera from its housing
    • Lift the back camera from its housing

    • The back camera may be glued to the phone

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Alexander Prasil

Membre depuis le 28/09/2017

534 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S1-G2, Nance Fall 2017 Membre de l'équipe USF Tampa, Team S1-G2, Nance Fall 2017

USFT-NANCE-F17S1G2

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 166