Introduction

This guide shows how to replace the LED screen. This is a more complicated guide because it involves removing the back plate of the watch along with the battery.

Wedge a plastic opening tool between band contacts.
  • Wedge a plastic opening tool between band contacts.

Ajouter un commentaire

Push in plastic opening tool until the components click and pop out of the holder.
  • Push in plastic opening tool until the components click and pop out of the holder.

  • Repeat steps for other band.

Ajouter un commentaire

  • Remove four 4mm screws using a PH000 screwdriver.

  • Remove back plate.

Ajouter un commentaire

  • Use tweezers to remove elastomeric, or zebra, connector.

Ajouter un commentaire

  • Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken.

Ajouter un commentaire

  • Use the pointy edge of the spudger tool to detach battery leads from the circuit board.

Ajouter un commentaire

  • Use PH000 screw driver to remove two 6mm bracketed screws.

  • Remove bracket.

Ajouter un commentaire

  • Use PH000 tool to remove two 4mm screws.

Ajouter un commentaire

Ajouter un commentaire

  • Use spudger tool to lift the clasp of LED connector strip and remove from watch case.

Ajouter un commentaire

  • Use spudger tool to remove the LED screen from the watch case.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kaitlyn Lee

Membre depuis le 06/11/2017

518 Réputation

4 tutoriels rédigés

Équipe

IUPUI, Team S6-G1, Baechle Fall 2017 Membre de l'équipe IUPUI, Team S6-G1, Baechle Fall 2017

IUPUI-BAECHLE-F17S6G1

4 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 5

Total : 59