Aller au contenu principal

Introduction

The projector's lamp is key to maintaining optimal image quality, and its periodic replacement is one of the most common tasks associated with owning a projector. All this replacement needs is a single screwdriver and about 5 minutes of your time.

Pièces

Aucune pièce spécifiée.

  1. Loosen the 2.5 mm Phillips #1 screw that holds the top assembly in place using a Philips #1 (PH1) screwdriver. This will enable you to lift and slide off the top cover.
    • Loosen the 2.5 mm Phillips #1 screw that holds the top assembly in place using a Philips #1 (PH1) screwdriver. This will enable you to lift and slide off the top cover.

    • Fully remove the top cover in order to get to the lamp housing.

  2. Carefully peel off the adhesive film covering the lamp housing.
    • Carefully peel off the adhesive film covering the lamp housing.

  3. Using a Phillips #1 (PH1) screwdriver, loosen and remove the single 2.5 mm Phillips #1 screw that secures the lamp housing to the projector.
    • Using a Phillips #1 (PH1) screwdriver, loosen and remove the single 2.5 mm Phillips #1 screw that secures the lamp housing to the projector.

  4. Remove the lamp from the projector by pulling on the lamp handle.
    • Remove the lamp from the projector by pulling on the lamp handle.

    • Apply more force on the side opposite of the newly removed screw as you pull the lamp out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Gabriela Remulla

Membre depuis le 26/09/2017

828 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team S6-G1, Banghart Fall 2017 Membre de l'équipe Cal Poly, Team S6-G1, Banghart Fall 2017

CPSU-BANGHART-F17S6G1

5 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 5

30 derniers jours : 14

Total : 1,086