Introduction

This guide explains how to replace the release button if it is broken or not working.

Press the release button while pulling up on the head of the vacuum to remove the head.
  • Press the release button while pulling up on the head of the vacuum to remove the head.

Ajouter un commentaire

Using  a Phillips head screwdriver, unscrew the four screws holding the panel to the shaft of the vacuum.
  • Using a Phillips head screwdriver, unscrew the four screws holding the panel to the shaft of the vacuum.

Ajouter un commentaire

  • Pry the panel up using a spudger and pull up firmly just enough to see the clips of wire on the sides.

Ajouter un commentaire

  • Remove the wire clips on both sides of the shaft.

Ajouter un commentaire

  • Pull the top piece out of the shaft.

Ajouter un commentaire

  • Pinch the two pairs of plastic catches (circled in the picture) to release the button.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Khanh Fleshman

Membre depuis le 28/01/2018

133 Réputation

1 tutoriel rédigé

Équipe

CPSU-BANGHART-W18S21G2 Membre de l'équipe CPSU-BANGHART-W18S21G2

Community

1 membre

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 28