Introduction

Upon completion of this guide, you can successfully install and replace the motor fan for you blender.

Before disassembling the blender base, make sure the blender disconnected from any power outlet.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

Ajouter un commentaire

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Ajouter un commentaire

  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

Ajouter un commentaire

  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

Ajouter un commentaire

  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Ajouter un commentaire

  • Using pliers, remove the top nut from the fan and remove the washer.

  • Use a small towel to hold the fan in place. This makes taking off the nut easier to do.

Ajouter un commentaire

  • Lift the fan blades from the blender base.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Andrew

Membre depuis le 04/10/2012

170 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 6-34, Regan Fall 2012 Membre de l'équipe Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 3

30 derniers jours : 22

Total : 2,493