Introduction

You will need to have completed the prerequisite guides prior to this guide in order to execute it.

Before disassembling the blender base, make sure the blender disconnected from any power outlet.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

Ajouter un commentaire

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Ajouter un commentaire

  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

Ajouter un commentaire

  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

Ajouter un commentaire

  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Ajouter un commentaire

  • Once you have the base removed, the circuit board should be clearly visible inside.

Ajouter un commentaire

  • Remove the four screws located on the circuit board.

    • Two are on the left side.

    • Two are on the right side.

Ajouter un commentaire

  • Remove the following soldered connections with a soldering iron:

    • Motor wires

    • Power cord wires

Ajouter un commentaire

  • Lift the circuit board straight up to remove it from the base.

Ajouter un commentaire

  • Once the circuit board has been freed from its screws it can be moved out of the way to gain access to the buttons.

  • A single screw must be removed from the top as shown.

Ajouter un commentaire

  • Push firmly from the outside of the blender on the face of the buttons to pop it out of its locked position.

Ajouter un commentaire

  • Provided is a front and a back view of a functioning button frame from the BL3000S.

  • Check for cracks, bends, debris, or missing extentions and fastens.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Austin Abernathy

Membre depuis le 05/10/2012

18 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 6-34, Regan Fall 2012 Membre de l'équipe Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 14

Total : 1,479