Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four screws on the back top side of the drill.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four screws that connect the chuck to the drill.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the five screws on the front side of the drill.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Gently grab both sides of the drill casing, and separate both sides from each other.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
At this point you should be able to separate both as illustrated.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
After following the prerequisite, the drill is now open.
-
The interior components can now be accessed.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Separate the top part(the chuck and motor) from the rest of the drill.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To remove the motor simply twist as illustrated in the picture.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
The three metal tips in the front are the ones that are controlled by the chuck to hold and release the screw.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To test the chuck twist the head as shown in the illustration.
-
If the three metal tips don't move upon twisting then the chuck isn't working effectively and will need to be replaced since the inside of the chuck can't be accessed.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.