Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Turn the toaster over with its backside face down.
-
Remove the two Phillips #4 1cm screws that attach the side panels.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Pull downwards (towards the bottom of the unit) and outward to remove the side panels.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the metal vent piece that is below the door.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the crumb tray (the bottom, metal panel) from the toaster unit.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the knobs by pulling them upward; they should slide right off.
-
When placing the knobs back on the unit, make sure the semicircle notch fits correctly in the hole so that the knobs don't fall off.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unhook the bottom of the the display panel from the toaster unit.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Begin to detach the back panel from the toaster unit.
-
Then, unhook the rest of the display panel.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Finish removing the outside cover by lifting the lid upward.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four Phillips #4 1 cm screws from the back of the unit.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Now, you can clean the outside units of the toaster oven.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two Phillips #4 1 cm screws that were under the faceplate.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Forcefully bend back the faceplate in order to get to the knob.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove switch from the opening it protrudes from.
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.