Introduction

Use this guide to replace the keypad buttons of your BlackBerry 7290 .

Pièces

Aucune pièce nécessaire.

  1. Apply pressure to the lock button on the back of the device.
    • Apply pressure to the lock button on the back of the device.

    • Slide the battery cover down towards the bottom of the device, revealing the battery compartment.

    Ajouter un commentaire

  2. Locate groove along the right side of the battery compartment.
    • Locate groove along the right side of the battery compartment.

    • Remove battery by prying between the battery and the groove.

    Ajouter un commentaire

    • Slide the SIM card holder to the left to unlock the SIM card.

    Ajouter un commentaire

    • Lift the SIM card holder up.

    • Gently remove the SIM card from the SIM card holder by sliding the card along the railing.

    Ajouter un commentaire

    • Locate the four screws along the perimeter of the back casing.

    • Remove the four top screws using a T-6 torx screwdriver.

    • The top four screws are .413 inches.

    Ajouter un commentaire

    • Locate two screws within the lower edge of the inner compartment.

    • Remove the two bottom screws using a T-6 torx screwdriver.

    • The bottom two screws are .2 inches in length.

    • The second picture displays the device after the six screws have been removed.

    Ajouter un commentaire

    • Use the plastic opening tool to apply pressure on the two clips that are located at the bottom of the phone.

    Ajouter un commentaire

    • Remove the back casing from the phone by lifting the unhooked portion, then slide the casing towards the top of the device.

    • Make sure all clips holding the case together are unhooked, so no damage is caused to the case.

    Ajouter un commentaire

    • Locate on the backside of the phone, a screw towards the top of the device.

    • Using a T-6 screwdriver, remove the screw.

    • After the screw has been removed, carefully lift the side button brace to reveal the side button.

    Ajouter un commentaire

    • To remove the phone's internals, start by loosening one side by pulling gently.

    Ajouter un commentaire

    • With one side loosened, simply lift the phone internals to separate from the front casing.

    Ajouter un commentaire

    • Turn the internals over to reveal the LCD display.

    Ajouter un commentaire

    • Peel off the rubber keypad buttons from the face plate.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

kmathew

Membre depuis le 17/10/2009

3 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 19-6, Maness Fall 2009 Membre de l'équipe Cal Poly, Team 19-6, Maness Fall 2009

CPSU-MANESS-F09S19G6

5 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 17

Total : 3,710