Introduction

Replace your cracked LCD screen with a new one.

Pièces

Aucune pièce nécessaire.

  1. Remove the battery cover by applying pressure and sliding down the silver square on the back of the phone.
    • Remove the battery cover by applying pressure and sliding down the silver square on the back of the phone.

  2. Remove the battery by prying under it with your finger or the plastic opening tool. Remove the four small 3/8" long screws using a 1/16" diameter torx screwdriver.
    • Remove the battery by prying under it with your finger or the plastic opening tool.

    • Remove the four small 3/8" long screws using a 1/16" diameter torx screwdriver.

  3. Use a nylon spudger to carefully remove the two side bars of plastic. Use a nylon spudger to carefully remove the two side bars of plastic.
    • Use a nylon spudger to carefully remove the two side bars of plastic.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Use a nylon spudger to carefully pry the back casing off.
    • Use a nylon spudger to carefully pry the back casing off.

    • There are two small clamps on each edge that need to be unhooked before the casing will come off.

  6. Pry off the front casing.
    • Pry off the front casing.

    • Be aware of sensors and other sensitive areas of the newly exposed electronics.

  7. After disassembling the outer casing, the phone should be stripped as shown.
    • After disassembling the outer casing, the phone should be stripped as shown.

  8. At the top of the phone, locate the gloss SATA cable strap connecting the LCD screen to the phone. Using the prying tool, unattach this cable by levering under the connector.
    • At the top of the phone, locate the gloss SATA cable strap connecting the LCD screen to the phone.

    • Using the prying tool, unattach this cable by levering under the connector.

  9. Using the prying tool, lever up the old screen as shown. WARNING: Be sure to have disconnected the SATA cable strap prior to attempting this.
    • Using the prying tool, lever up the old screen as shown.

    • WARNING: Be sure to have disconnected the SATA cable strap prior to attempting this.

  10. Insert new LCD screen. Attach cable to the connector located at the top of the phone.
    • Insert new LCD screen.

    • Attach cable to the connector located at the top of the phone.

    • Phone should look as it was prior to screen removal.

Conclusion

To reassemble your device, follow these instructions in reverse order.

ryan

Membre depuis le 12/04/2013

41 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 13-64, Johann Spring 2013 Membre de l'équipe Cal Poly, Team 13-64, Johann Spring 2013

CPSU-JOHANN-S13S13G64

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 476