Pièces

Aucune pièce nécessaire.

Place the phone on a flat surface with the screen facing down.
  • Place the phone on a flat surface with the screen facing down.

  • Remove the plastic backplate by pulling up on the bottom of the cover.

Ajouter un commentaire

Remove the battery by pulling up from the top of the battery.
  • Remove the battery by pulling up from the top of the battery.

Ajouter un commentaire

  • Remove the two screws midway up the phone on the left and right sides using a T6 Torx Screwdriver.

  • Warning: One screw will have warranty tape covering the screw. Removing this screw will likely void the phones warranty.

Ajouter un commentaire

  • Flip the phone over so the keyboard faces up.

  • Insert a plastic spudger into the screen where speaker resides.

  • I recommend going from the side. There are two layers to the cover. You need to make sure you get underneath the bottom layer if you plan on reusing this cover.

  • Gently lift up plastic screen cover until screen cover separates from screen.

  • Continue until screen cover is completely removed.

Ajouter un commentaire

  • Insert the spudger into the top of the plastic siding on the front of the phone and lift up until the siding lifts up.

  • Slide the tool around the entire perimeter of the phone until the plastic siding is completely removed.

Ajouter un commentaire

  • The keyboard should slide off of the phone now that the plastic siding has been removed.

Ajouter un commentaire

  • To detach the screen, there are two screws at the top of the phone to be removed. Use the T6 Torx Screwdriver to remove the screws.

  • There is a gold ribbon on the top left of the phone. Lift up this ribbon gently until it is detached from the phone.

    • Note: When reassembling, the ribbon should be reattached before replacing the top screws.

Ajouter un commentaire

  • There are two clips on each side of the phone. Insert a plastic spudger between the clips and the screen.

  • Use pressure to unlatch the screen from the clips.

  • Now that these clips have been undone, the screen should lift up easily.

Ajouter un commentaire

  • Now there are four screws that need to be removed. They are located at the bottom of the phone and can also be removed using a T6 Torx Screwdriver.

Ajouter un commentaire

  • Now the motherboard will lift up out of the plastic backing of the phone.

Ajouter un commentaire

Ligne d'arrivée

10 autre(s) ont terminé cette réparation.

Cory Davis

Membre depuis le 19/04/2011

503 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 15-13, Regan Spring 2011 Membre de l'équipe Cal Poly, Team 15-13, Regan Spring 2011

CPSU-REGAN-S11S15G13

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 18

Total : 10,349