Introduction
The purpose is to remove both the main circuit board and the roller ball unit from the main frame of the phone.
Ce dont vous avez besoin
-
-
Remove four screws total on the back of the phone casing near edge of battery area.
-
Two screws that are closer to the top of the phone are protected by plastic stoppers. Remove them then remove the screws.
-
There are two more screws on either side of where the battery was located. remove them as well.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.