Introduction

Outline what you are going to teach someone how to do.

Pièces

Aucune pièce nécessaire.

  1. Before beginning this installation, make sure phone is powered off .
    • Before beginning this installation, make sure phone is powered off .

    • Turn phone over to the backside.

    • Press down on the lower portion of the back cover.

    • Slide the lower portion down to remove the cover and reveal the battery.

    Ajouter un commentaire

  2. Remove the battery from the phone.
    • Remove the battery from the phone.

    Ajouter un commentaire

    • Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.

    Ajouter un commentaire

    • Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.

    Ajouter un commentaire

    • Remove the back casing using the Plastic Opening Tool

      • Once the back casing is removed the top two buttons are likely to pop out.

    Ajouter un commentaire

    • Locate the two 9.2mm screws on the upper inside casing

    • Remove them using the T4 Torx Screwdriver

    • Slide off the front casing once the screws are removed.

      • Trackball will fall out once the casing is removed.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Martha de Maria y Campos

Membre depuis le 12/04/2012

55 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 17-27, Amido Spring 2012 Membre de l'équipe Cal Poly, Team 17-27, Amido Spring 2012

CPSU-AMIDO-S12S17G27

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 508