Pièces

Aucune pièce nécessaire.

  1. Before beginning this installation, make sure phone is powered off . Turn phone over to the backside. Press down on the lower portion of the back cover.
    • Before beginning this installation, make sure phone is powered off .

    • Turn phone over to the backside.

    • Press down on the lower portion of the back cover.

    • Slide the lower portion down to remove the cover and reveal the battery.

  2. Remove the battery from the phone.
    • Remove the battery from the phone.

  3. Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver. Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.
    • Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.
    • Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.

  6. Remove the back casing using the Plastic Opening Tool Once the back casing is removed the top two buttons are likely to pop out.
    • Remove the back casing using the Plastic Opening Tool

    • Once the back casing is removed the top two buttons are likely to pop out.

  7. Locate the two 9.2mm screws on the upper inside casing Remove them using the T4 Torx Screwdriver Slide off the front casing once the screws are removed.
    • Locate the two 9.2mm screws on the upper inside casing

    • Remove them using the T4 Torx Screwdriver

    • Slide off the front casing once the screws are removed.

    • Trackball will fall out once the casing is removed.

  8. Disconnect the tab attached to the interior casing from the LCD Screen by gently pulling the tab up and away from the phone. Use the Plastic Opening Tool to pry the LCD Screen out. Use the Plastic Opening Tool to pry the LCD Screen out.
    • Disconnect the tab attached to the interior casing from the LCD Screen by gently pulling the tab up and away from the phone.

    • Use the Plastic Opening Tool to pry the LCD Screen out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Martha de Maria y Campos

Membre depuis le 12/04/2012

55 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 17-27, Amido Spring 2012 Membre de l'équipe Cal Poly, Team 17-27, Amido Spring 2012

CPSU-AMIDO-S12S17G27

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 373