Aller au contenu principal

Introduction

Replacing the back case of the BlackBerry Bold 9900 is a tedious task, but it will allow you to become more familiar with your device, increase the lifespan of the device, and reduce e-waste.

Pièces

Aucune pièce spécifiée.

  1. Place phone screen down.
    • Place phone screen down.

    • Use your finger to life upward on the battery case.

    • Pull the cover away from the battery.

  2. Lift the edge of battery with the green stripe upward to remove battery.
    • Lift the edge of battery with the green stripe upward to remove battery.

  3. The Memory Card is located inside the red rectangle.
    • The Memory Card is located inside the red rectangle.

    • To remove the Memory Card, push and slide the card inward towards the top of the phone. It will be ejected.

  4. The SIM Card is located where the red rectangle is shown. To remove SIM Card, push the card inward towards the top of the phone then release. The SIM card will be ejected.
    • The SIM Card is located where the red rectangle is shown.

    • To remove SIM Card, push the card inward towards the top of the phone then release. The SIM card will be ejected.

  5. Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now

    Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now
  6. Lift the bezel at the bottom of the phone up and peel it away from the phone. Lift the bezel at the bottom of the phone up and peel it away from the phone.
    • Lift the bezel at the bottom of the phone up and peel it away from the phone.

  7. Remove the two exposed screws using the T5 Torx screwdriver. Remove the two exposed screws using the T5 Torx screwdriver.
    • Remove the two exposed screws using the T5 Torx screwdriver.

  8. Now lever the keyboard up using the screwdriver in the indicated hole.
    • Now lever the keyboard up using the screwdriver in the indicated hole.

  9. The keyboard is attached via a ribbon cable. Pull the cable up to remove the keyboard. The keyboard is attached via a ribbon cable. Pull the cable up to remove the keyboard.
    • The keyboard is attached via a ribbon cable. Pull the cable up to remove the keyboard.

  10. Using the T5 Torx Screwdriver, remove the four torx screws that are located on the bottom half of the device
    • Using the T5 Torx Screwdriver, remove the four torx screws that are located on the bottom half of the device

  11. Now, carefully and gently using your fingers, lift and remove the assembly from the back case.
    • Now, carefully and gently using your fingers, lift and remove the assembly from the back case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sowmika

Membre depuis le 30/01/2018

169 Réputation

2 tutoriels rédigés

Équipe

Baylor, Team S1-G4, Johnson Spring 2018 Membre de l'équipe Baylor, Team S1-G4, Johnson Spring 2018

BU-JOHNSON-S18S1G4

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 31

Total : 603