Introduction

This guide was written to aid with Blackberry Curve screen replacement. Following the steps below should provide relatively simple means of achieving this goal.

Place your Blackberry face down in front of you.
  • Place your Blackberry face down in front of you.

Ajouter un commentaire

Locate the indent on the bottom of the back cover.
  • Locate the indent on the bottom of the back cover.

  • Use your fingernail to lift and remove the back cover.

Ajouter un commentaire

  • From the top, use your fingernail to lift and remove the battery.

Ajouter un commentaire

  • Use the T6 Torx screwdriver to unscrew the two 5mm screws highlighted.

Ajouter un commentaire

  • Place the phone face up and use tweezers to securely grip and lift the screen upwards.

Ajouter un commentaire

  • Use your prying tool to lift the bottom edge of the front cover.

Ajouter un commentaire

  • Use your nails to unclip sides of frame from the phone.

Ajouter un commentaire

  • Lift and remove frame.

Ajouter un commentaire

  • Lift and remove keyboard.

Ajouter un commentaire

  • Locate and remove the two 5mm screws on top of keyboard base using the T6 Torx screwdriver

Ajouter un commentaire

  • Carefully pull keyboard base up and away from phone.

  • Disconnect keyboard base from phone completely.

Ajouter un commentaire

  • Locate and remove the four 5mm screws on the top and bottom of phone using the T6 Torx screwdriver

Ajouter un commentaire

  • Using a prying tool, find the crease below the screen.

  • Insert where shown and use the tool to unclip the two sides of screen from body.

    • Prying tool goes approximately midway between the top and bottom edge of the screen.

Ajouter un commentaire

  • From back of the phone, use finger to push the front piece of the phone away from the back piece.

Ajouter un commentaire

  • Using a prying tool, detach the ribbon cable from the top left corner of the screen and remove from phone.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

8 autre(s) ont terminé cette réparation.

Alek Squires

Membre depuis le 30/09/2013

415 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 14-7, Forte Fall 2013 Membre de l'équipe Cal Poly, Team 14-7, Forte Fall 2013

CPSU-FORTE-F13S14G7

5 membres

5 tutoriels rédigés

would appreciate new ldc part # and order info! - - !

Donald Burgo - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 8

30 derniers jours : 29

Total : 3,644