Réparez vos affaires Communauté Boutique

Blackberry Torch 9800 Logic Board Replacement

Introduction

This guide takes you through the steps to remove a logic board in a Blackberry Torch 9800. Installing the new logic board is the same process, in reverse. This project will void your phone warranty.

Ce dont vous avez besoin

  1. Blackberry Torch 9800 Logic Board Replacement, Logic Board Replacement: étape 1, image 1 de 2 Blackberry Torch 9800 Logic Board Replacement, Logic Board Replacement: étape 1, image 2 de 2

    • Remove the back cover and the battery.

    • Unscrew the four screws using a T6 screwdriver.

    • Removing the top right screw (with the blue cover) will void the warranty.

    Modifier

  2. Blackberry Torch 9800 Logic Board Replacement: étape 2, image 1 de 2 Blackberry Torch 9800 Logic Board Replacement: étape 2, image 2 de 2

    • Remove the side trim using the plastic opening tool.

    • Apply pressure to push the top side of the side trim towards the phone while pulling the bottom away from the phone to remove the side trim.

    • The side trim is fragile and easily fractured, so handful it with care.

    Modifier

  4. Blackberry Torch 9800 Logic Board Replacement: étape 3, image 1 de 3 Blackberry Torch 9800 Logic Board Replacement: étape 3, image 2 de 3 Blackberry Torch 9800 Logic Board Replacement: étape 3, image 3 de 3

    • Remove the two screws that have been revealed at the top of the device using the T6 screwdriver.

    • You should now be able to easily lift the back panel from the phone.

    Modifier

  5. Blackberry Torch 9800 Logic Board Replacement: étape 4, image 1 de 2 Blackberry Torch 9800 Logic Board Replacement: étape 4, image 2 de 2

    • Using your hands, carefully peel the three ribbon cable caps from the logic board.

    Modifier

  6. Blackberry Torch 9800 Logic Board Replacement: étape 5, image 1 de 2 Blackberry Torch 9800 Logic Board Replacement: étape 5, image 2 de 2

    • Lift logic board slightly. The logic board will remain attached to the phone by a small antenna wire.

    • Using your hands, carefully lift the clasp attached to the antenna wire straight upward away from the logic board.

    • Make sure not to disconnect the antenna wire from its clasp.

    • The logic board should now be completely separate from the phone.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Auteur

avec 5 autres contributeurs

Keegan Williams

Membre depuis le 02/19/16

216 Réputation

2 tutoriels rédigés

Badges: 6

+ 3 badges supplémentaires

Équipe

Ohio State, Team 1-5, Garvin Spring 2016 Membre de l'équipe Ohio State, Team 1-5, Garvin Spring 2016

OSU-GARVIN-S16S1G5

3 membres

3 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 5

30 derniers jours : 11

Total : 842