Aller au contenu principal

Introduction

If you need to replace the speakers of your Bose SoundLink Mini, follow this guide. The speakers are the main components in this device, and after time or bad wiring connection they may become unresponsive and need to be replaced. They are located deep within the body of the device and a several other parts will be needed to be removed before the two speakers can be accessed. Make sure you have all the necessary tools and follow all prerequisite guides in order to replace the two speaker parts.

Pièces

Aucune pièce spécifiée.

  1. Bose SoundLink Mini Speakers Replacement, Battery: étape 1, image 1 de 1
    • Peel back the rubber battery cover and remove the four circled 6.0 mm screws using a T8 Torx Screwdriver.

    Help I removed the part which I'm not supposed to next to the battery charger how do I put it back?

    Sooraj murali - Réponse

    Where can I actually get a replacement battery????

    appreciate any help bc I couldn’t find it anywhere.

    Kamil M. - Réponse

    Where can I get an actual replacement battery???

    appreciate any help bc I couldn’t find it anywhere.

    Kamil M. - Réponse

    Hi Brent and thank you for this easy fix.

    Still I have a problem I did not have while the original battery was in place: the sound is now buzzing even at a middle-of-the-range volume.

    I used the original screws and everything seems in place and the screws are tightened “right” I would say. I am usually fine fixing things. And I do not see what I could have done wrong…

    Any suggestion?

    Thank you.

    MBP - Réponse

    Which battery is the correct one. Two model are shown to be purchase

    Ruben Roman - Réponse

    What is not discussed is the wires that connect the battery to the speaker. In mine, I think I destroyed the speaker, because I pulled out the battery and dislodged the wires from the electronic board. I think they must have been soldered on, and now am having trouble attaching the new wires to the board.

    horseylawgal - Réponse

    I have lost the 4 battery screws. What size are they? I think they are metric but what is the length? They were Philips head flat as I remember.

    Wolfgang Mitchell - Réponse

  2. Bose SoundLink Mini Speakers Replacement: étape 2, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 2, image 2 de 2
    • While holding the cover back, pull straight up on the battery to remove it.

    Where can I buy this battery

    Karsten lou nielsen - Réponse

    Well that part was simple. What I need is how to disconnect the ribbon cable which is soldered in on both ends. No help here.

    Art Kennedy - Réponse

    soweit sogut..aber die Kabel sind verlötet ?

    das ist ja das problem

    also sehr schlechte Anleitung da ja das wichtigste fehlt !!

    Armin Karl - Réponse

    Bonjour pas aussi simple car les câbles de la batterie d origine sont soudés…

    Lionel Ludosky - Réponse

    On remark though: the original Bose battery has a thin foam gasket at the base. This foam gasket makes sure the room behind the speakers is airtight, which is essential for a clean sound. Most aftermarket batteries do not have this gasket, leading to a thumping noise when you turn up the music. This is easy to fix: with a sharp cutter, gently peel the gasket from the original battery and reinstall is on the new battery. That solved the problem for me. Alternatively, you can cut a think sheet of PE foam to fit the base of battery.

    philippe.bleiman - Réponse

    Cable is not soldered on BOSE SoundLink Mini!

    The situation is different on BOSE SoundLink Mini II. The procedure to replace battery is more demanding as the cable is soldered.

    france.gartner - Réponse

  3. Bose SoundLink Mini Speakers Replacement, Front/Back Protective Grille: étape 3, image 1 de 1
    • Insert the Metal Spudger between the rubber edge on the grille and the aluminum casing.

    • Place Metal Spudger in the location shown.

    Woher bekomme ich nun rin solches Vorder- und Rückgitter?

    [COBS]CR4ZY BLITZ - Réponse

  4. Bose SoundLink Mini Speakers Replacement: étape 4, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 4, image 2 de 2
    • Slowly pry up the grille until the two tabs shown pop out.

    • Be very gentle, the grille will bend.

  5. Bose SoundLink Mini Speakers Replacement: étape 5, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 5, image 2 de 2
    • The grille is attached to the speaker with double sided sticky tape. To remove the grill gently pull upward while keeping tension to the right.

    • Be very gentle, the grille will bend.

  6. Bose SoundLink Mini Speakers Replacement: étape 6, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 6, image 2 de 2
    • Repeat steps to remove the back grille.

  7. Bose SoundLink Mini Speakers Replacement, Battery Cover: étape 7, image 1 de 2 Bose SoundLink Mini Speakers Replacement, Battery Cover: étape 7, image 2 de 2
    • Remove the four 15.0 mm screws on the left and the four 9.0 mm screws on the right using the T8 Torx Screwdriver.

  8. Bose SoundLink Mini Speakers Replacement: étape 8, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 8, image 2 de 2
    • Remove the circuit board by pushing it with your index finger in the direction shown while using a nylon or metal spudger to lift it up and out of place.

  9. Bose SoundLink Mini Speakers Replacement: étape 9, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 9, image 2 de 2
    • Carefully pull on the battery cover until the rubber tab slides out of the aluminum casing.

    I just want to emphasize that the rubber tab (that is part of the cover) is supposed to sit ON TOP of the circuit board. In my case, my son managed to pull of the battery cover off completely, so as I was taking it apart I didn’t see how the rubber tab was actually supposed to sit inside the box. Because these instructions have you unseat the circuit board, I thought it was implying the tab was supposed to sit under the circuit board. But that is NOT the case! If I had looked at the pictures 7 and 9 more carefully, I would have seen how things were supposed to sit. Instead I first jammed things back together with the rubber underneath the board (really hard to do), only to find that the slightly squeezed rubber tab pushed the cover out a millimeter so it wouldn’t sit right on the charger. On closer inspection, I figured things out.

    Matthew Busche - Réponse

  10. Bose SoundLink Mini Speakers Replacement, Button Switch Circuit Board: étape 10, image 1 de 1
    • Remove the sponge (save for later replacement) and gently flip the black tab 90 degrees to release the connectors grip on the ribbon cable. Remove the ribbon cable from the connector.

    • The black tab must be flipped up in order to reinsert the ribbon cable on reassembly.

    there’s supposed to be a wire strips lock behind that small,gray foam,careful fellas don’t end it like me,i just simply pulling it off until it teared apart the board, also it broked,and until know i haven’t fix it yet

    Kikay CianancyTM - Réponse

    Button Switch Circuit Board is cut in my speaker what I do for it

    bodapati pramchand1997 - Réponse

  11. Bose SoundLink Mini Speakers Replacement: étape 11, image 1 de 3 Bose SoundLink Mini Speakers Replacement: étape 11, image 2 de 3 Bose SoundLink Mini Speakers Replacement: étape 11, image 3 de 3
    • Use a Metal Spudger to pry up the plastic divider.

  12. Bose SoundLink Mini Speakers Replacement: étape 12, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 12, image 2 de 2
    • When removing the plastic divider be careful not to damage the wire strip sliding through it.

  13. Bose SoundLink Mini Speakers Replacement: étape 13, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 13, image 2 de 2
    • Reach through the battery compartment hole and unplug the power strip shown.

    Hi ineed complete surkit bord for bose sound link mini speaker

    Ajay kumar - Réponse

    Bose sound link mini 1 complete surkit prece?

    Ajay kumar - Réponse

    How many pins a ribbon wire

    Rio Aldene Frani - Réponse

  14. Bose SoundLink Mini Speakers Replacement: étape 14, image 1 de 3 Bose SoundLink Mini Speakers Replacement: étape 14, image 2 de 3 Bose SoundLink Mini Speakers Replacement: étape 14, image 3 de 3
    • Remove both circuit boards by wiggling them up and out of the casing.

    • Unplug the speaker wires connected and fully remove both circuit boards.

    • When unplugging the speaker wires, squeeze the white connector piece to release the wires.

  15. Bose SoundLink Mini Speakers Replacement: étape 15, image 1 de 2 Bose SoundLink Mini Speakers Replacement: étape 15, image 2 de 2
    • Unhook the speaker wires clipped onto the button switch circuit board.

  16. Bose SoundLink Mini Speakers Replacement: étape 16, image 1 de 3 Bose SoundLink Mini Speakers Replacement: étape 16, image 2 de 3 Bose SoundLink Mini Speakers Replacement: étape 16, image 3 de 3
    • Use a nylon or metal spudger to slightly lift up on the button switch circuit board.

    • Pull the button switch circuit board straight out from the casing.

    Hi

    my bose SoundLink mini keep flashing ember light even it’s plugged into AC adapter,can you tell me how can I get it update

    Moqdam Aljwrany - Réponse

    hi dear

    hpe you are fine .dear need me one IC of this divice if posiable please inform me .thanks

    Aamir MAlik - Réponse

  17. Bose SoundLink Mini Speakers Replacement, Speakers: étape 17, image 1 de 2 Bose SoundLink Mini Speakers Replacement, Speakers: étape 17, image 2 de 2
    • Remove the eight 9.0 mm screws using the T8 Torx Screwdriver.

    Where can i find the spare speakers?

    Ricardo ferreira - Réponse

  18. Bose SoundLink Mini Speakers Replacement: étape 18, image 1 de 3 Bose SoundLink Mini Speakers Replacement: étape 18, image 2 de 3 Bose SoundLink Mini Speakers Replacement: étape 18, image 3 de 3
    • Using a nylon or metal spudger, pry up the plastic divider and remove it.

  19. Bose SoundLink Mini Speakers Replacement: étape 19, image 1 de 3 Bose SoundLink Mini Speakers Replacement: étape 19, image 2 de 3 Bose SoundLink Mini Speakers Replacement: étape 19, image 3 de 3
    • Gently lift the speakers up and out of the casing.

    Speaker dimensions pls L*w*h

    syalusg - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

16 autres ont terminé cette réparation.

Jordan Smith

Membre depuis le 01/10/2015

851 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 1-23, Maness Fall 2015 Membre de l'équipe Cal Poly, Team 1-23, Maness Fall 2015

CPSU-MANESS-F15S1G23

4 membres

19 tutoriels rédigés

16 commentaires

This is great! Well done! Thank you. I dropped mine and there's not any sound now. What would you think happened and where should i start?

[deleted] - Réponse

Perhaps open it up and then use a multimeter or some other speakers to see if you're getting any output from the amplifier? Sometimes the speaker drivers are damaged by dropping.

Larry Chen -

Do you know the part number for the speaker or where to buy it ? After a trip to the beach I now have a cracking sound in one of the speakers.

Thanks for the help

Javier Sanchez - Réponse

Hi,

Where can i buy genuine Bose replacement speakers for the Soundlink?

Scott - Réponse

Do you know if the the other speakers were passive radiators or powered subwoofers? Bose claims that the are subwoofers but I'm skeptical

Thomas Catanzarita - Réponse

Hi, do you know if the oval speakers in the center of the speaker on the front and back are passive radiators or subwoofers? Bose claims that they are subwoofers but I'm skeptical and I doubt they are.

Thomas Catanzarita - Réponse

hello

its passive radiators

i do not know where to find those speakers ,i need those too

and for speaker model and other parts this will help :

https://www.google.mu/url?sa=t&rct=j&q=&...

neelmadhav dookhit - Réponse

Hi, my Mini 2 has the main PCB faulty .  Do you know where can I find any spare parts?

Stefano Chiadini - Réponse

Please how can I get my bose mini replacement speakers my is sounding like I’m trying to tone on radio

Bright chizzy - Réponse

This article is not much help unless spare parts can be purchased. I can tear apart all day long and put back together but would really like to purchase “new" speakers!

Darby Skelley - Réponse

speakers part number : bose 360563-0030 just hard to find…

tefiparis - Réponse

Where can i buy the full case replacement?

carllesther.asy - Réponse

Does anyone know what the dimensions of the speakers are in Bose Sound Link Mini? What is the best replacement?

Thanks,

Dino

Edin Handzic - Réponse

Shed can I get replacement part BT-T11-V4.1 got Bose sound like mini.

jimmy hayhow - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 14

7 derniers jours : 85

30 derniers jours : 382

Total : 35,650