Réparez vos affaires Communauté Boutique

Braun Series 7 790cc-7 Charging Base Wire Harness Replacement

Introduction

The charging base wire harness is essential to the function of the Braun Series 7 790cc-7 charging base. Many consumers may discard the charging base if it cannot be used to charge and clean the razor. This can be expensive but by replacing a faulty charging harness the razor can be used with the charging base again. With the use of this Replacement Guide, one can easily change the charging base harness if required.

Ce dont vous avez besoin

  1. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement, Charging base wire harness: étape 1, image 1 de 1

    • Remove the cleaner cartridge from the charging base.

    Modifier

  2. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 2, image 1 de 3 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 2, image 2 de 3 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 2, image 3 de 3

    • Depress the 4 tabs while lightly pulling the cover from the base.

    • Next, depress the 2 molded tabs while still pulling the cover from the base.

    Modifier

  4. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 3, image 1 de 1

    • Press inward on the side charging port while pulling cover from the base to separate.

    Modifier

  5. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 4, image 1 de 2 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 4, image 2 de 2

    • Remove side charging port by prying tabs outward and rotating port upward.

    Modifier

  6. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 5, image 1 de 2 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 5, image 2 de 2

    • Remove charging terminals by inserting a spudger from bottom the and sliding terminals up.

    Modifier

  7. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 6, image 1 de 2 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: étape 6, image 2 de 2

    • Remove solder from circuit board and remove charging harness.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Auteur

avec 2 autres contributeurs

Ian Hayes

Membre depuis le 11/07/17

216 Réputation

2 tutoriels rédigés

Badges: 6

+ 3 badges supplémentaires

Équipe

IUPUI, Team S3-G6, Harley Fall 2017 Membre de l'équipe IUPUI, Team S3-G6, Harley Fall 2017

IUPUI-HARLEY-F17S3G6

3 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 2

30 derniers jours : 9

Total : 1,067