Introduction

Replacing the On/Off switch should the wiring become faulty.

Use a Phillips #0 screwdriver to remove the following ten screws:
  • Use a Phillips #0 screwdriver to remove the following ten screws:

    • Four 18mm Phillips screws.

    • Four 9.75mm Phillips screws.

    • Two 8mm Phillips screws.

    • The cover will not remove entirely. Keep green ground wire attached to the cover.

Ajouter un commentaire

Remove the two 14.5 Phillips screws.
  • Remove the two 14.5 Phillips screws.

  • Ensure that only the water inlet valve can be moved.

Ajouter un commentaire

  • Use a Phillips #0 screwdriver to remove the following six screws:

    • Six 14.5mm Phillips screws.

Ajouter un commentaire

    • Remove the power cord from the groove. (the black cord that leads into the green wire.)

    • This creates more slack in the wire to give you more room to work with.

    • DO NOT remove green wire from the cover its attached to.

Ajouter un commentaire

  • Carefully pull out the Red and Blue wires that covered at the tip.

  • Do not yank them out from the other end. Move them aside and out of the way.

Ajouter un commentaire

  • Carefully remove the On/Off Switch from its slot on the outside cover.

  • The wires for the switch will need to be tied back to the wires leading to the battery. If necessary, use electrical tape.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Antonio

Membre depuis le 26/09/2012

73 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 1-3, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 1-3, Propen Fall 2012

CPSU-PROPEN-F12S1G3

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 15

30 derniers jours : 31

Total : 2,111