Aller au contenu principal

Introduction

This guide describes the steps necessary to replace the motherboard of the system. This board contains the circuitry for the amplification, power, and output.

  1. Remove 2 screws from each side of the amplifier.
    • Remove 2 screws from each side of the amplifier.

  2. Remove 2 screws on rear of device. Slide top cover up and back from main case.
    • Remove 2 screws on rear of device. Slide top cover up and back from main case.

  3. Remove 3 screws on bottom of case. Remove 13 screws on rear panel.
    • Remove 3 screws on bottom of case.

    • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

  4. Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now

    Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now
  5. Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.
    • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

    • It may require some wiggling, but it should slip out of the hole and then off of the cord.

  6. Remove 2 screws from each side of the heatsink. These must be accessed from directly above the device.
    • Remove 2 screws from each side of the heatsink. These must be accessed from directly above the device.

    • Remove the green grounding wire from the mounting screw.

  7. With the amplifier on it's side, remove the 4 screws that hold the motherboard frame to the main case.
    • With the amplifier on it's side, remove the 4 screws that hold the motherboard frame to the main case.

    • Be sure to hold the motherboard with one hand while removing the mount screws.

  8. Unscrew ground wire from main case. De solder 4 wires coming from transformer.
    • Unscrew ground wire from main case.

    • De solder 4 wires coming from transformer.

    • The motherboard can now be lifted from the case. Any part that needs to be removed from it can be de-soldered.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Colby

Membre depuis le 15/04/2010

284 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 28-36, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-36, Regan Spring 2010

CPSU-REGAN-S10S28G36

4 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 19

Total : 5,472