Campbell Hausfeld FP204800 Shroud Disassembly

Introduction

Removing the shroud of the compressor can be tricky because of wiring that is difficult to see during disassembly. Make sure you carefully read each step of this guide so you do not damage the compressor when removing the shroud.

Ce dont vous avez besoin

Étape 1 Remove Shroud Screws

Campbell Hausfeld FP204800 Shroud Disassembly, Remove Shroud Screws: étape 1, image 1 de 3

Campbell Hausfeld FP204800 Shroud Disassembly, Remove Shroud Screws: étape 1, image 2 de 3

Campbell Hausfeld FP204800 Shroud Disassembly, Remove Shroud Screws: étape 1, image 3 de 3

Unscrew the four 1cm long shroud screws using a 6mm Allen Wrench.

Modifier

Étape 2 Remove Shroud

Campbell Hausfeld FP204800 Shroud Disassembly, Remove Shroud: étape 2, image 1 de 2

Campbell Hausfeld FP204800 Shroud Disassembly, Remove Shroud: étape 2, image 2 de 2

Remove the plastic shroud from the compressor.
Do not pull the shroud too far from the compressor. You could damage the on/off switch wiring.

Modifier

Étape 3 Remove The Wiring From the Pressure Switch to the On/Off Switch

Campbell Hausfeld FP204800 Shroud Disassembly, Remove The Wiring From the Pressure Switch to the On/Off Switch: étape 3, image 1 de 1

Gently pull the wire attached from the pressure switch to the on/off switch.
It should come off the pressure switch with ease.
Make sure you are pulling the correct wire. The pressure switch could be in a different configuration on your compressor than in the picture.

Modifier

Étape 4 Remove the On/Off Switch Wiring

Campbell Hausfeld FP204800 Shroud Disassembly, Remove the On/Off Switch Wiring: étape 4, image 1 de 1

Gently pull the wire connected from the on/off switch to the motor of the compressor.
It should be the only wire keeping the shroud from being lifted from the compressor.

Modifier