Canary CAN100USBK Audio and USB PCB Board Replacement

Introduction

The audio jack is not used for audio, but for streaming setup data from your phone to the Canary, so it is very important to replace if damaged.

Once you remove the bottom casing and Ethernet PCB board, the audio and USB PCB board becomes accessible. Remember to pull on the power connector itself and not the wires to avoid damage.

If either the audio jack or USB type C connector are damaged, this guide will show you how to replace the board.

A Phillips #0 screwdriver can be used for both screws.

Ce dont vous avez besoin

Étape 1 Bottom Casing

Canary CAN100USBK Audio and USB PCB Board Replacement, Bottom Casing: étape 1, image 1 de 2

Canary CAN100USBK Audio and USB PCB Board Replacement, Bottom Casing: étape 1, image 2 de 2

Grip the rubber ring with your fingers and pull up.
Rotate the Canary as you pull out one tab at a time.

Modifier

Étape 2

Use your Phillips #0 screwdriver to remove the four 6mm screws.

Modifier

Étape 3

Canary CAN100USBK Audio and USB PCB Board Replacement: étape 3, image 3 de 3

Use the flat end of the spudger to carefully pry off the bottom casing.
Alternate pushing up on the left and right sides until the clips holding the case in are visible.

Modifier

Étape 4

Do not yank the bottom off or you may damage the ribbon cable or the ZIF connector.
Carefully remove the bottom casing by gripping it on both sides and pulling straight up.

Modifier

Étape 5

Use the pointed end of the spudger to flip up the small retaining flap on the ZIF (zero insertion force) connector.
Pull the ribbon cable out towards the device.

Modifier

Étape 6 Ethernet PCB Board

Canary CAN100USBK Audio and USB PCB Board Replacement, Ethernet PCB Board: étape 6, image 1 de 1

Use your Phillips #0 screwdriver to remove the three 5mm screws.

Modifier

Étape 7

Place the flat end of the spudger underneath the Ethernet PCB board and slowly pry up until it's loose.

Modifier

Étape 8

Carefully pull the Ethernet PCB board away from the board that sits underneath.

Modifier

Étape 9 Audio and USB PCB Board

Canary CAN100USBK Audio and USB PCB Board Replacement, Audio and USB PCB Board: étape 9, image 1 de 1

Using your fingernails, wiggle the power connector back and forth until it becomes loose.
Pull the power connector straight out of the socket.
Pull only on the power connector and not the wires themselves to prevent damage.