Aller au contenu principal

Introduction

If the back lock-release lever is loose or broken, this will allow you to attempt to replace it.

Pièces

Aucune pièce spécifiée.

  1. Open up the battery door. Open up the battery door. Open up the battery door.
    • Open up the battery door.

  2. Remove the batteries from the camera by sliding them out into your palm. Remove the batteries from the camera by sliding them out into your palm.
    • Remove the batteries from the camera by sliding them out into your palm.

  3. Release the side latch to open the back panel. Release the side latch to open the back panel.
    • Release the side latch to open the back panel.

  4. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  5. Remove the two black 4.5mm screws above and below the latch. Remove the two black 4.5mm screws above and below the latch.
    • Remove the two black 4.5mm screws above and below the latch.

  6. Using your finger, carefully pry open the side panel from the top of camera. Pull panel downwards to remove.
    • Using your finger, carefully pry open the side panel from the top of camera.

    • Pull panel downwards to remove.

    • Make sure to keep track of the small black piece of rubber under the latch.

  7. Remove the two silver 6mm Phillips #1 screws. Remove the two silver 6mm Phillips #1 screws.
    • Remove the two silver 6mm Phillips #1 screws.

  8. Flip camera over to the bottom. Remove the one 5mm Phillips #1 silver screw.
    • Flip camera over to the bottom.

    • Remove the one 5mm Phillips #1 silver screw.

  9. Remove the front panel by pulling away from the side with the lever. Remove the front panel by pulling away from the side with the lever.
    • Remove the front panel by pulling away from the side with the lever.

  10. Pull off the lever by pushing up from the bottom and pulling away from the bottom. Pull off the lever by pushing up from the bottom and pulling away from the bottom. Pull off the lever by pushing up from the bottom and pulling away from the bottom.
    • Pull off the lever by pushing up from the bottom and pulling away from the bottom.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jordan Tang

Membre depuis le 24/01/2014

534 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 6-20, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 9

Total : 676