Introduction

If the camera is not turning on, the batteries may need to be replaced.

Pièces

Aucune pièce nécessaire.

  1. Open up the battery door.
    • Open up the battery door.

    Ajouter un commentaire

  2. Remove the batteries from the camera by sliding them out into your palm.
    • Remove the batteries from the camera by sliding them out into your palm.

    Ajouter un commentaire

    • Release the side latch to open the back panel.

    Ajouter un commentaire

    • Remove the two black 4.5mm screws above and below the latch.

    Ajouter un commentaire

    • Using your finger, carefully pry open the side panel from the top of camera.

    • Pull panel downwards to remove.

    • Make sure to keep track of the small black piece of rubber under the latch.

    Ajouter un commentaire

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the two silver 6mm Phillips #1 screws.

    Ajouter un commentaire

    • Flip camera over to the bottom.

    • Remove the one 5mm Phillips #1 silver screw.

    Ajouter un commentaire

    • Remove the front panel by pulling away from the side with the lever.

    Ajouter un commentaire

    • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

    • Remove five black 4.8mm Phillips #1 screws.

    Ajouter un commentaire

    • Simply remove the bottom panel by prying it off with your finger.

    • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

    • Be wary of a loose piece of foam attached to the bottom panel.

    Ajouter un commentaire

    • Remove the remote control socket cover.

    Ajouter un commentaire

    • Remove two black 4.5mm Phillips #1 screws.

    Ajouter un commentaire

    • Remove two black 4.8mm Phillips #1 screws on the front of the camera.

    Ajouter un commentaire

    • Pry open the side grip using a spudger.

    Ajouter un commentaire

    • Remove one black 5mm Phillips #1 screw.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jordan Tang

Membre depuis le 24/01/2014

531 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 6-20, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 23

Total : 837