Introduction

Taking off the top of the camera allows repair access to the eye piece and command dial.

Pièces

Aucune pièce nécessaire.

Open up the battery door.
  • Open up the battery door.

Ajouter un commentaire

Remove the batteries from the camera by sliding them out into your palm.
  • Remove the batteries from the camera by sliding them out into your palm.

Ajouter un commentaire

  • Release the side latch to open the back panel.

Ajouter un commentaire

  • Remove the two black 4.5mm screws above and below the latch.

Ajouter un commentaire

  • Using your finger, carefully pry open the side panel from the top of camera.

  • Pull panel downwards to remove.

  • Make sure to keep track of the small black piece of rubber under the latch.

Ajouter un commentaire

  • Remove the two silver 6mm Phillips #1 screws.

Ajouter un commentaire

  • Flip camera over to the bottom.

  • Remove the one 5mm Phillips #1 silver screw.

Ajouter un commentaire

  • Remove the front panel by pulling away from the side with the lever.

Ajouter un commentaire

  • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

  • Remove five black 4.8mm Phillips #1 screws.

Ajouter un commentaire

  • Simply remove the bottom panel by prying it off with your finger.

  • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

  • Be wary of a loose piece of foam attached to the bottom panel.

Ajouter un commentaire

  • Remove the remote control socket cover.

Ajouter un commentaire

  • Remove two black 4.5mm Phillips #1 screws.

Ajouter un commentaire

  • Remove two black 4.8mm Phillips #1 screws on the front of the camera.

Ajouter un commentaire

  • Pry open the side grip using a spudger.

Ajouter un commentaire

  • With your hands, remove the rubber grip from the eye piece.

Ajouter un commentaire

  • Remove the eyecup from the eyepiece by pushing the eyecup up.

Ajouter un commentaire

  • Remove two silver 5.0mm Phillips #1 screws.

Ajouter un commentaire

  • Remove the silver 5.5mm Phillips #1 screw.

Ajouter un commentaire

  • Pry the top silver part of the camera off.

  • Buttons may slip out of the camera's top as the top is pulled off the camera (shown in picture two).

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tammy Kong

Membre depuis le 23/01/2014

643 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 6-20, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 6

Total : 232