Introduction

This will allow you access to the ports, or if you need to replace the dust cover, will allow you to do that.

Pièces

Aucune pièce nécessaire.

Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.
  • Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.

  • Repeat for the other two grips

  • The large one on the battery-side is the easiest to start with. This is required to remove the front & back panels

  • The small one on the back is a bit difficult to get started, but not really difficult to remove.

  • The one on the AV panel will be easier if you open up the AV port cover.

  • Remove the adhesive like you would rubber cement, just rub your finger against it, it will come off.

  • Optionally throw the balled up adhesive at people pretending its a booger :)

Ajouter un commentaire

Remove 3 screws
  • Remove 3 screws

Ajouter un commentaire

  • Using a Spudger, fingernail, or other thin plastic tool to wedge the panel off of the camera

  • Start at the camera's front. Pulling on the rubber av-cover may be enough to get it to move off the body

  • Only pull about 1/4" (3-5mm). There is a tab that will need to slide out

Ajouter un commentaire

  • Slide the rear part of the cover out.

Ajouter un commentaire

  • At this point, the only thing holding on is the dust-cover is hooked onto the front panel

  • Slide down to remove without damaging the cover. (see photo with cover removed)

  • You can see how the cover, and side piece fit together in the second image.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

Eric D

Membre depuis le 13/11/2012

1 026 Réputation

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 12

30 derniers jours : 44

Total : 5,396