Réparez vos affaires Communauté Boutique

Canon EOS 60D Left-Side Port Cover Replacement

Introduction

This will allow you access to the ports, or if you need to replace the dust cover, will allow you to do that.

Ce dont vous avez besoin

  1. Canon EOS 60D Left-Side Port Cover Replacement, Rubber grips: étape 1, image 1 de 1

    • Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.

    • Repeat for the other two grips

    • The large one on the battery-side is the easiest to start with. This is required to remove the front & back panels

    • The small one on the back is a bit difficult to get started, but not really difficult to remove.

    • The one on the AV panel will be easier if you open up the AV port cover.

    • Remove the adhesive like you would rubber cement, just rub your finger against it, it will come off.

    • Optionally throw the balled up adhesive at people pretending its a booger :)

    Traduire

  2. Canon EOS 60D Left-Side Port Cover Replacement, Left-Side Port Cover: étape 2, image 1 de 1

    • Remove 3 screws

    Traduire

    • Remove the small Screw under the Flip cover too

    Traduire

  5. Canon EOS 60D Left-Side Port Cover Replacement: étape 4, image 1 de 1

    • Using a Spudger, fingernail, or other thin plastic tool to wedge the panel off of the camera

    • Start at the camera's front. Pulling on the rubber av-cover may be enough to get it to move off the body

    • Only pull about 1/4" (3-5mm). There is a tab that will need to slide out

    Traduire

  6. Canon EOS 60D Left-Side Port Cover Replacement: étape 5, image 1 de 1

    • Slide the rear part of the cover out.

    Traduire

  7. Canon EOS 60D Left-Side Port Cover Replacement: étape 6, image 1 de 2 Canon EOS 60D Left-Side Port Cover Replacement: étape 6, image 2 de 2

    • At this point, the only thing holding on is the dust-cover is hooked onto the front panel

    • Slide down to remove without damaging the cover. (see photo with cover removed)

    • You can see how the cover, and side piece fit together in the second image.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

7 autres ont terminé cette réparation.

Auteur

avec 2 autres contributeurs

Eric D

Membre depuis le 11/13/12

1 284 Réputation

5 tutoriels rédigés

Badges: 15

+ 12 badges supplémentaires

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 29

Total : 7,249