Aller au contenu principal

Introduction

The grips for the 60D come off easy, they just peel off. For many 60D owners, Canon already helped you by choosing a poor / defective adhesive for the first few batches of cameras shipped.

Pièces

Aucune pièce spécifiée.

  1. Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.
    • Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.

    • Repeat for the other two grips

    • The large one on the battery-side is the easiest to start with. This is required to remove the front & back panels

    • The small one on the back is a bit difficult to get started, but not really difficult to remove.

    • The one on the AV panel will be easier if you open up the AV port cover.

    • Remove the adhesive like you would rubber cement, just rub your finger against it, it will come off.

    • Optionally throw the balled up adhesive at people pretending its a booger :)

  2. Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now

    Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now
Conclusion

Double stick tape, or rubber cement (placed carefully) should work well. Studio-mount (sheets of double-stick tape) cut to size should also work.

10 autre(s) ont terminé cette réparation.

Eric D

Membre depuis le 13/11/2012

1 107 Réputation

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 12

30 derniers jours : 43

Total : 10,324