Introduction

In this guide, you will learn how to replace the main board in the EFS 18-135mm lens. The main board is crucial to the correct operation of the lens, passing focus commands from the camera to the lens.

Pièces

Aucune pièce nécessaire.

First, detach the lens by pressing and holding the release button highlighted in the picture.
  • First, detach the lens by pressing and holding the release button highlighted in the picture.

  • Next, grab the lens and rotate it counter-clockwise when looking at the camera.

  • Finally, when the camera stops rotating, pull the lens away from the camera.

Ajouter un commentaire

Remove the four 5.5-mm Phillips #000 screws for the lens mount ring (silver ring).
  • Remove the four 5.5-mm Phillips #000 screws for the lens mount ring (silver ring).

  • Remove the two 4-mm Phillips #000 screws mounting the main board connector.

  • This guide involves removing a lot of very small screws so be sure to have a magnet board to keep track of them.

Ajouter un commentaire

  • Using a spudger, pull the connector loose from the barrel switch ring assembly.

  • Set barrel switch ring assembly to the side.

Ajouter un commentaire

  • Using a spudger, pull the five connectors out of their housing.

  • Use very gentle pressure when pulling connectors out of the lens main board, as they tend to break easily.

Ajouter un commentaire

  • Remove the two 4-mm Phillips #000 main board mounting screws.

  • Remove the main board from the lens with your hand.

  • The main board is now successfully removed from the lens.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Paul

Membre depuis le 12/03/2018

462 Réputation

3 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 8

30 derniers jours : 30

Total : 115