Introduction

Use this guide to replace the interior eyepiece of the camera.

Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
  • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

Ajouter un commentaire

On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
  • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

  • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

Ajouter un commentaire

Remove three medium length screws from the bottom of the camera
  • Remove three medium length screws from the bottom of the camera

Ajouter un commentaire

Remove the two medium length screws on the front panel of the camera above the lens mount.
  • Remove the two medium length screws on the front panel of the camera above the lens mount.

  • Once you done, you may use the Spudger to panel from non-grip side.

  • If you start on the grip side, it will be more challenging to loosen the panel.

Ajouter un commentaire

Remove the three long black screws from the bottom using a #00 Phillips screwdriver.
  • Remove the three long black screws from the bottom using a #00 Phillips screwdriver.

  • Use tweezers to lift the panel.

Ajouter un commentaire

Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.
  • Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.

Ajouter un commentaire

Remove the following ribbons with the tweezers by gently pulling on them.
  • Remove the following ribbons with the tweezers by gently pulling on them.

  • Remove the three black screws, near the eye piece, using the Phillips Screwdriver.

Ajouter un commentaire

Remove the cable heads attached on the front side of the camera next to the lens mount.
  • Remove the cable heads attached on the front side of the camera next to the lens mount.

  • Be gentle when puling wires lose, use the tweezers to remove the wires.

Ajouter un commentaire

You can use your fingers to pull the top panel of the camera.
  • You can use your fingers to pull the top panel of the camera.

Ajouter un commentaire

After removing the top panel, you can use your fingers to remove the eye piece from the camera.
  • After removing the top panel, you can use your fingers to remove the eye piece from the camera.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel Bussone

Membre depuis le 28/01/2011

1 206 Réputation

11 tutoriels rédigés

Équipe

Cal Poly, Team 3-41, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 membres

11 tutoriels rédigés

Is there a part number to order the interior eyepiece? It does me no good to take it apart if I don't have or can't find a replacement for it.

Erik - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 15

Total : 6,119