Introduction

Use this guide to remove the lens mount ring. This particular Canon SLR has a plastic lens mount ring that can wear faster than the metal lens mount rings on other models.

Pièces

Aucune pièce nécessaire.

  1. Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
    • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

  2. On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
    • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

    • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

  3. Remove three medium length screws from the bottom of the camera
    • Remove three medium length screws from the bottom of the camera

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Remove the two medium length screws on the front panel of the camera above the lens mount.
    • Remove the two medium length screws on the front panel of the camera above the lens mount.

    • Once you done, you may use the Spudger to panel from non-grip side.

    • If you start on the grip side, it will be more challenging to loosen the panel.

  6. Remove the five silver screws from the lens mounting ring using a Phillips screwdriver.
    • Remove the five silver screws from the lens mounting ring using a Phillips screwdriver.

  7. Use your fingers to remove the lens mounting ring.
    • Use your fingers to remove the lens mounting ring.

    • There is a small metal button housed in the ring (red square). Be careful not to lose this piece when removing the ring.

  8. Use a pair of tweezers to remove the spring on the lens mounting ring.
    • Use a pair of tweezers to remove the spring on the lens mounting ring.

  9. Use a pair of tweezers to remove the gold metal ring.
    • Use a pair of tweezers to remove the gold metal ring.

    • Take note of the ring's orientation for re-installing it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Daniel Bussone

Membre depuis le 28/01/2011

1 239 Réputation

11 tutoriels rédigés

Équipe

Cal Poly, Team 3-41, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 9

30 derniers jours : 37

Total : 6,730