Introduction

This replacement is not easy and takes a considerable amount of time. This guide will show you how to safely remove the ink head from your printer.

There are a few tabs on the top of the panel that hook down and into the black side panel. Insert the tool in-between the black panel and the blue panel as shown and pull the two pieces apart.
  • There are a few tabs on the top of the panel that hook down and into the black side panel. Insert the tool in-between the black panel and the blue panel as shown and pull the two pieces apart.

  • You will hear some snapping. Don't panic: this is just the hooks un-clipping.

Ajouter un commentaire

Repeat the same process as the left side panel.
  • Repeat the same process as the left side panel.

Ajouter un commentaire

  • Unhook the lid support by sliding the hook down and to the left. Make sure the support is fully disconnected before proceeding.

Ajouter un commentaire

  • Remove the four black screws on the back panels from both the left and right side.

Ajouter un commentaire

  • Remove the scanner by pulling the side panels out until the scanner pin is free. Set the scanner aside.

  • The scanner will still be attached with wires on the right side. Be careful not to yank the part away from the main body of the printer

Ajouter un commentaire

  • Press down on the clip on the left side of the printer until it clicks, and pull the panel free.

Ajouter un commentaire

  • Press down on the clip on the right side panel until it clicks, and the pull the panel free.

Ajouter un commentaire

  • Remove the plastic cover by depressing the clip located on the right side of the printer. Press the clip inwards until it clicks, and then lift the cover upwards and off the printer.

Ajouter un commentaire

  • Unscrew the three screws holding the rail.

Ajouter un commentaire

  • Remove the cord by pulling upwards on it and unhooking it from the pulleys on either end.

Ajouter un commentaire

  • Remove the ink head by pulling it away from the rail.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Val Fedorikhin

Membre depuis le 12/10/2014

860 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 6-21, Maness Fall 2014 Membre de l'équipe Cal Poly, Team 6-21, Maness Fall 2014

CPSU-MANESS-F14S6G21

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 29

Total : 1,602