Difficulté
Modérée
Étapes
18
Temps nécessaire
1 heure
- Outer Casing 4 étapes
- LCD Screen 2 étapes
- Motherboard 12 étapes
Police de grammaire
Réveillez le prof qui sommeille en vous et aidez-nous à améliorer l'orthographe de ce tutoriel !
Tutoriel vedette
L'équipe iFixit trouve ce tutoriel particulièrement réussi.
Introduction
This guide serves to remove and replace the motherboard.
Pièces
Aucune pièce nécessaire.
-
Remove the knot on the wrist lanyard.
-
Remove the battery and memory card.
-
Remove all screws from sides of outer casing.
-
Begin removing the screws on the bottom of the outer casing.
-
Remove the rest of the screws from the outer casing.
-
Gently pull the front cover off the camera.
-
Open the "A/V Out Digital" cover slide, and remove the screw inside.
-
Gently pull off the back casing.
-
Remove the black "L" shaped piece of metal.
-
Remove the three screws that are holding the screen in place and free the screen from the underlying components.
-
With the spudger, gently lift the black flap that is holding the wide ribbon cable wire in place.
-
Unplug the wide ribbon cable.
-
Unplug the narrow ribbon cable to free the LCD screen from the camera body
The author failed to mention a couple things. First, the screen is in a holder which you remove, then after pulling off some electrical tape, you have to yank the actual screen out. Second, I only had two screws to pull the screen holder out, not three. Third, the thing that you have to pull to get the screen ribbon cable out is actually a tiny black hinge, so don't worry if it suddenly snaps back. Finally, to put the thing back together, it really helps if you have a tweezers to get the ribbon cables back into place.
and fyi replacement screens available from canon parts department for about 50 bucks.
-
Remove the screws holding down function set button.
-
Gently pry up the tab with a metal spudger and remove the ribbon cable.
-
Be mindful of the pins as you lift up and remove the function/set button.
-
Remove the screws from the metal plate.
-
Gently remove the metal plate.
-
Lift the tab connecting the ribbon cable and detach.
-
Use a spudger to lift up the ribbon cable tab.
-
Detach the ribbon cable.
-
Gently remove the entire ribbon cable connection to release the ribbon cable from the camera.
-
Unscrew the circuit board from the flash unit.
-
Pry up the ribbon cable connection and remove it from the camera.
-
Lift the ribbon cable tab and completely detach the cable from the camera.
-
Pry up the connection, being mindful of the light adhesive.
-
Remove the last screw holding the motherboard to the main body.
-
Use a spudger to gently lift the motherboard from the camera.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce guide.
2 autre(s) ont terminé cette réparation.
Équipe
Cal Poly, Team 19-5, Maness SU 2012 Membre de l'équipe Cal Poly, Team 19-5, Maness SU 2012
CPSU-MANESS-SU12S19G5
1 membre
5 tutoriels rédigés
