Introduction

The Canon PowerShot SD200 has a 3.7V Lithium-ion battery that requires it to be removed from the camera in order for it to be charged. This guide will show you how to remove the battery from the camera assembly.

The camera used to create these repair guides had a broken lens assembly.  As a result, the lens is sticking out in all of the photos, but it is important to note that this should not be the case with your camera.  The lens should retract itself back into the camera when it is turned off.
  • The camera used to create these repair guides had a broken lens assembly. As a result, the lens is sticking out in all of the photos, but it is important to note that this should not be the case with your camera. The lens should retract itself back into the camera when it is turned off.

  • Use your fingernail to slide the dark gray tab located on the bottom of the device towards the edge of camera.

  • Slide the light gray door away from the LCD screen and pull up to open the door.

  • Both battery and memory card should now be visible.

Ajouter un commentaire

Rotate the small brown tab towards the edge of the camera.
  • Rotate the small brown tab towards the edge of the camera.

  • The battery should pop up.

Ajouter un commentaire

  • Pull the battery straight out of the battery holder.

  • When putting the battery back in, make sure it is orientated the same as it was before.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

James Loy

Membre depuis le 06/10/2010

103 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 5-12, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 5-12, Maness Fall 2010

CPSU-MANESS-F10S5G12

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 2,606