Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use your fingernail to slide the dark gray tab located on the bottom of the device towards the edge of camera.
-
Slide the light gray door away from the LCD screen and pull up to open the door.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Rotate the small brown tab towards the edge of the camera.
-
The battery should pop up.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Pull the battery straight out of the battery holder.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Close the light gray battery compartment door.
-
Remove the six 2.8 mm Phillips screws on the outside of the case. Two screws are found on each side of the camera, and the final two are found on the bottom.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use your fingers to carefully pry off the back casing from the camera assembly.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Push the buttons out with your finger if they did not fall out while removing the casing.
-
Pull off the white plastic side piece if it did not fall out while removing the casing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the one 2.2 mm Phillips screw from the bottom of the camera.
-
Take off the print button.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use your fingers to carefully pry off the front casing of the camera. The front casing should pull straight off.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of the spudger to lift open the white plastic latch on the front of the camera. Once the latch is lifted up, move the latch up towards the top edge of the camera.
-
Remove the top button assembly by pulling straight up.
-