Introduction

Use this repair guide to replace a broken LCD screen on your Canon PowerShot SD870 IS.

Pièces

Aucune pièce nécessaire.

  1. Remove the wrist strap, if present.
    • Remove the wrist strap, if present.

    • Remove the lithium-ion battery.

  2. Remove the two 4 mm Phillips #00 screws on the bottom of the camera.
    • Remove the two 4 mm Phillips #00 screws on the bottom of the camera.

    • Remove the screw next to the wrist strap attachment.

    • Pull up the “A/V OUT DIGITAL” cover and remove the screw above the USB port.

    • Carefully unhook the “A/V OUT DIGITAL” cover from the hinge.

    • Pull the front cover from the camera by using gentle upward pressure.

    • Remove the two Phillips #00 screws from the flat end of the camera.

    • Remove the black L-shaped side cover plate.

    • Remove the silver u-shaped retainer plate.

    • Slide the back casing off.

    • The first screw that needs to be removed is located on the bottom of the camera, on the left hand side.

      • Using a Phillips #00 screwdriver remove the 0.133in silver screw on the bottom left-hand side.

    • The second screw that needs to be removed is located on the top of the camera.

      • Using the same Phillips head screwdriver, remove the last 0.133in silver screw.

        • This will detach a silver U-shaped piece that was holding LCD screen on. Remove the piece and put it to the side.

    • The LCD screen should now only be attached by the LCD data cable.

      • Lift the screen from the right side and use a small screwdriver or other small opening device to flip the black portion of the connector upward to unlock it.

      • Carefully slide the data cable out of the connector.

        • The LCD should still be connected by the backlight cable.

    • To remove the backlight cable, use another small opening device to unlock the backlight cable.

      • Carefully slide out the backlight cable.

        • The LCD screen should now be fully detached from the camera body.

    • The LCD screen casing is connected by 4 claws located on the top and bottom on the left and right hand side.

      • Carefully disengage the claws by gently prying them off one by one.

        • Once the claws are disengaged, the back of the casing will still be connected to the front casing by the backlight cable.

      • Carefully peel the backlight cable off of the casing.

    • The LCD screen and housing should now be in three pieces:

      • LCD screen

      • LCD screen frame

      • LCD screen back housing

    • The LCD screen itself can now be removed and fixed/replaced.

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Sam

Membre depuis le 15/04/2010

134 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 10-45, Garner Spring 2010 Membre de l'équipe Cal Poly, Team 10-45, Garner Spring 2010

CPSU-GARNER-S10S10G45

4 membres

6 tutoriels rédigés

if not taking the battery out before beginning this repair damaged the camera... thanks for not making mention of that...

Dan - Réponse

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 12

Total : 17,332