Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a Phillips #00 screwdriver to remove the two 3.4 mm screws on the left side of the camera.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the same screwdriver, remove the two 3.4 mm screws on the bottom of the camera.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the small plastic tab, located on the front of the camera, to remove the GPS cover.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the same Phillips screwdriver, remove the two screws that hold the LCD screen.
-
Remove the other small tab attached to the LCD screen.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
When removing the plastic casting, do not pull it all the way off. Detach the small tab first and make sure nothing else is attached to the casing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To remove the tabs from the camera, remove all screws.
-
Slowly lift the screen out of the camera using the tabs.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the tabs, outlined in red, to slowly remove the LCD screen.
-
Remove the screws to remove the camera motherboard.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert the replacement LCD screen.
-
Ensure that the long strip is attached to the original position.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To reassemble your device, follow Steps 2 to 9 in reverse order.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.