Introduction
Replace the func. set turn dial of the Canon PowerShot SX50 HS.
Ce dont vous avez besoin
-
-
Locate the battery compartment on the bottom of the camera.
-
Push the latch on the outside of the battery door to the right to get to the battery pack inside.
-
-
-
Remove the two Phillips #000 screws, length 5 mm, on either side of the viewfinder.
-
Remove the one Phillips #000 screw, length 4 mm, on the bottom, closer to the back side of the camera.
-
-
-
-
Remove the four Phillips #000 screws, length 3 mm, attaching the metal panel to the inside of the back encasement.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
2 commentaires
Interested to know where I can buy the switch/ribbon assembly for that function dial?
I appreciated the clear instructions and photos. Couldn’t be any better. Now I would like to know where to purchase the dial assembly.