Aller au contenu principal

Introduction

This guide explains the location of exterior screws and the process to remove the rear panel of the Canon Powershot A70 camera.

Pièces

Aucune pièce spécifiée.

  1. Unscrew the three small screws on the bottom of the camera with a Phillips #00 screwdriver.
    • Unscrew the three small screws on the bottom of the camera with a Phillips #00 screwdriver.

    • Remove the wrist strap.

  2. Remove the screw in the CF compartment with a Phillips #00 screwdriver.
    • Remove the screw in the CF compartment with a Phillips #00 screwdriver.

  3. Open the rubber Digital AV Out compartment flap. Pry the battery with an opening tool. Carefully pull out the battery with two fingers.
    • Open the rubber Digital AV Out compartment flap.

    • Pry the battery with an opening tool.

    • Carefully pull out the battery with two fingers.

    • Remove the two screws that are now visible with a Phillips #00 screwdriver.

  4. Starting from the bottom, carefully pull the casing off. The casing will now pivot at the top.
    • Starting from the bottom, carefully pull the casing off.

    • The casing will now pivot at the top.

    • There are three catches that hold the back casing to the body.

    • You may have to pull with some force. The rear panel will make a snapping noise when it separates from the body.

  5. The interior of the camera should look like this.
    • The interior of the camera should look like this.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Shalan Ertis

Membre depuis le 26/01/2010

68 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 14-40, Regan Winter 2010 Membre de l'équipe Cal Poly, Team 14-40, Regan Winter 2010

CPSU-REGAN-W10S14G40

5 membres

15 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 4

Total : 3,103