Introduction

The motherboard controls the operations of the camera. Damage to the motherboard requires an entirely new motherboard.

Pièces

Aucune pièce nécessaire.

Slide grey latch to open the battery compartment.
  • Slide grey latch to open the battery compartment.

Ajouter un commentaire

Push orange retaining clip to the right to free battery.
  • Push orange retaining clip to the right to free battery.

Ajouter un commentaire

  • Remove battery from the camera.

Ajouter un commentaire

  • Remove the lanyard.

Ajouter un commentaire

  • Remove the two 2.3mm screws (underneath the name plate) and two 2.8mm screws (next to the threaded tripod mount) from the bottom face of the camera.

  • Be careful to keep track of the different screw sizes as you proceed with this guide.

Ajouter un commentaire

  • Remove the single 3.8mm screw from the back face of the camera.

Ajouter un commentaire

  • Remove the two 2.3mm screws from the right face of the camera.

Ajouter un commentaire

  • Remove the two 3.2mm screws (outside edge) and two 3.7mm screws (towards middle) from the left side of the camera body.

Ajouter un commentaire

  • Pull the back face panel away from the front end of the body. This may take some wiggling and force.

Ajouter un commentaire

  • Remove the CF card door from the left side of the camera body.

Ajouter un commentaire

  • Remove the rubber digital a/v out cap by sliding it out of the groove on the front plate.

Ajouter un commentaire

  • Remove the front face by sliding it off.

Ajouter un commentaire

  • Remove the rubber seal that goes over the right side of the viewfinder.

Ajouter un commentaire

  • Remove the two 3.9mm screws that retain the laminated cooper sheet.

Ajouter un commentaire

  • Remove the seven wire connections that connect to the motherboard.

Ajouter un commentaire

  • Remove the single 3.8mm screw that is on the motherboard.

Ajouter un commentaire

  • Carefully remove the motherboard from the main frame of the camera body.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Orlando Zuniga

Membre depuis le 14/04/2011

11 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 20-70, Walters Spring 2011 Membre de l'équipe Cal Poly, Team 20-70, Walters Spring 2011

CPSU-WALTERS-S11S20G70

5 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 1,605