Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
First, take the base of the device and flip it over.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four 12 mm Phillips #2 screws surrounding the base then lift the bottom half of the base to expose the circuit boards inside the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two 7.5 mm Phillips #2 screws holding in the motherboard
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unplug the wire going into the side of the motherboard
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the metal spudger to cut open the rubber covering the latch where it clamps onto the copper tab.
-
Unplug wire at heating element by first using the metal spudger to push the latch in and then pushing it out.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two 7.5mm Phillips #2 screws from the metal frame.
-
Remove the frame from the assembly.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two 6mm fine thread Phillips #2 screws attaching the small computer chip to the metal frame.
-
Flip over and remove the 7.5 mm fine thread Phillips #2 screw from the back while holding the 5mm nut on the front securely.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Find the cable that attaches the small computer chip to the heating element connections.
-
Use the spudger to cut open the rubber coating on the latch where it clamps onto the copper tab.
-
Insert the metal spudger into the rectangular hole on the latch and push toward the tab (away from the wire) to unbend the tab.
-
Push the latch off the tab with the spudger.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Identify the two computer chips that connect the two yellow wires to the temperature controls.
-
Remove the four 5 mm Phillips #1 screws.
-
Remove the two computer chips from their places.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Find the computer chip over the dial.
-
Remove the three 6mm Phillips #2 screws.
-
Remove the computer chip.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unplug the four cables on the left side of the chip.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.