Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Flip the keyboard over so that the bottom is facing up.
-
Remove the twenty-seven 12 mm screws from the dark-grey panel using a Phillips #2 screwdriver.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the bottom panel by lifting and pulling it towards yourself.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Flip open the top half of the keyboard.
-
Set the keyboard onto the bottom half with the internal parts facing up.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Plug in the soldering iron.
-
Unscrew the top green circuit board with black and red wires running through it.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Set the circuit board somewhere flat so it is safe to solder.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Heat up the solder covering the end of the wires connected to the circuit board.
-
Once the solder melts, remove the wires from the circuit board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Melt new solder with your soldering iron.
-
Then apply it over the tip of the wire resting on the circuit board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Once the wires are firmly attached, screw the circuit board back into the keyboard.
-
Annulation : je n'ai pas terminé ce tutoriel.
3 autres ont terminé cette réparation.