Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Place the meter face down, and the back panel and screws can be seen.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the back panel of the device by lifting upward.
-
Remove the battery from the meter before continuing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four 7mm Phillips screws holding the circuit board in place.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Gently lift the circuit board away from the device casing.
-
Annulation : je n'ai pas terminé ce tutoriel.
6 autres ont terminé cette réparation.
Un commentaire
What is the little dial on the circuit board on the upper right that has numbers 1 through 3 on it and it can be adjusted thank you