Aller au contenu principal

Introduction

Disassembly guide for Cisco Aironet 1242ag Access Point

Outils

Pièces

Aucune pièce spécifiée.

  1. The equipment cover is held by 4 screws. The equipment cover is held by 4 screws.
    • The equipment cover is held by 4 screws.

  2. Once the 4 screws are removed, push to the side to remove the cover.
    • Once the 4 screws are removed, push to the side to remove the cover.

  3. The card is attached to the bottom plate by 4 screws Before removing the logic board, disconnect the antenna cables in both parts of the device. There is a total of 4 cables. Use a tweezer or a spudger to disconnect them.
    • The card is attached to the bottom plate by 4 screws

    • Before removing the logic board, disconnect the antenna cables in both parts of the device.

    • There is a total of 4 cables. Use a tweezer or a spudger to disconnect them.

  4. Write the wisdom here. Write the wisdom here. Write the wisdom here.
    • Write the wisdom here.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Merci à ces traducteurs :

100%

Ces traducteurs nous aident réparer le monde ! Vous voulez contribuer ?
Commencez à traduire ›

Pièces jointes

Eneider Colina

Membre depuis le 20/09/2013

1 442 Réputation

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 286