Press the eject button to view the laser inside.
  • Press the eject button to view the laser inside.

  • Using the blue plastic tool and the tweezers, remove the ribbon cable.

Ajouter un commentaire

Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.
  • Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.

  • Do not lift the top of the DVD player too quickly because there are wires attached on the inside.

  • Pry the top of the device open from the right side where the buttons are located.

Ajouter un commentaire

  • When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.

  • Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

Ajouter un commentaire

  • Position the DVD player so that the power and AVI ports are facing you.

  • Pull the white cable with the blue adapters off of the circuit boards.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Yufay Chow

Membre depuis le 23/01/2012

92 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 10-36, Amido Winter 2012 Membre de l'équipe Cal Poly, Team 10-36, Amido Winter 2012

CPSU-AMIDO-W12S10G36

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 791