Difficulté
Modérée
Étapes
20
Temps nécessaire
20 minutes
- LED Cover 8 étapes
- Keyboard 3 étapes
- Palm Rest 7 étapes
- Floppy Drive 2 étapes
Conditions préalables manquantes
Ce tutoriel ne donne pas d'informations sur le début de la procédure. Créez un tutoriel de conditions préalables !
Photos d’action
Montrez ce dont un héros est capable ! Ce tutoriel a besoin d'images pour mieux illustrer certaines opérations spécifiques.
Texte bizarre
Certaines parties de ce texte sont confuses, répétitives ou hors-sujet. Modifie-les pour les rendre plus claires !
Une étape a été sautée
Oups ! Il manque encore des étapes importantes à ce tutoriel.
Problème de balisage
Ce tutoriel nécessite de meilleures balises. Améliorez-le par des corrections ou des annotations de balisage.
Introduction
A guide on how to remove the Floppy Drive.
Pièces
Aucune pièce nécessaire.
-
Turn the laptop bottom side up with the rear panel facing forward.
-
Remove the two T8 Torx screws that secure the LED cover to the base enclosure.
-
Turn the laptop top side up with the front facing forward. Open the screen.
-
Locate the F1 and F2 keys near the top left corner of the keyboard.
-
While holding the F1 and F2 keys, insert a spudger between the keys into the notch in the LED cover. Lift up.
-
Locate the Pause and Scroll keys near the top right corner of the keyboard.
-
While holding the Pause and Scroll keys, insert a spudger between the keys into the notch in the LED cover. Lift up.
-
Insert a spudger between the F7 and F8 keys. Lift up to remove the LED cover.
-
Lift the back edge of the keyboard and pull towards the screen.
-
Pull the cable and lift up to release.
-
Remove the keyboard.
-
Flip the computer bottom side up with the rear facing forward.
-
Remove the six screws shown in picture.
-
Remove battery and then remove screw in metal support on case edge
-
Flip the computer top side up with the front facing you.
-
Lift up the palm rest from the front edge and swing it towards the screen.
-
Locate the first connector. Disconnect by firmly pulling up.
-
Locate the second connector. Remove by firmly pulling up.
-
Remove the palm rest.
-
Locate and remove the three screws shown in picture.
-
Lift up and remove floppy drive from the palm rest.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Équipe
Cal Poly, Team 29-74, Johann Spring 2010 Membre de l'équipe Cal Poly, Team 29-74, Johann Spring 2010
CPSU-JOHANN-S10S29G74
3 membres
7 tutoriels rédigés
