Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

This guide will show how to remove and replace the display assembly on a Compaq Presario CQ60-211DX laptop.

Pièces

Aucune pièce spécifiée.

  1. Start by making sure the CQ60 is powered down and that the disk drive is empty.
    • Start by making sure the CQ60 is powered down and that the disk drive is empty.

    • Flip the device over and remove the battery.

  2. Remove the rubber screw covers next to each of the two screen hinges using a metal spudger. Unscrew the screws underneath the rubber cover using the blank  Phillips-head screwdriver.
    • Remove the rubber screw covers next to each of the two screen hinges using a metal spudger.

    • Unscrew the screws underneath the rubber cover using the blank Phillips-head screwdriver.

  3. Use the metal spudger to gently pry the plastic faceplate off the rest of the display. Use the metal spudger to gently pry the plastic faceplate off the rest of the display.
    • Use the metal spudger to gently pry the plastic faceplate off the rest of the display.

  4. Kits pour Nintendo Switch

    Une solution rapide pour reprendre le jeu

    Acheter un kit pour Switch

    Kits pour Nintendo Switch

    Une solution rapide pour reprendre le jeu

    Acheter un kit pour Switch
  5. Unscrew the two screws in the top corners to separate the frame holding the assembly from the plastic of the lid.
    • Unscrew the two screws in the top corners to separate the frame holding the assembly from the plastic of the lid.

  6. Disconnect the assembly from the chip located between the hinges by pulling the wires to the right.
    • Disconnect the assembly from the chip located between the hinges by pulling the wires to the right.

  7. Pull the frame forward, and then unscrew the three screws on each side.
    • Pull the frame forward, and then unscrew the three screws on each side.

  8. Disconnect the ribbon cable on the back of the display by peeling back the tape and then pulling down on the cable.
    • Disconnect the ribbon cable on the back of the display by peeling back the tape and then pulling down on the cable.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Garrett Carter

Membre depuis le 21/09/2018

471 Réputation

4 tutoriels rédigés

Équipe

My laptop model Compaq predario cq61 h

Rashid 007 - Réponse

Computer on but display light of computer is running

Rashid 007 - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 9

Total : 260